Select Static IP drop-down menu and enter the following info: WAN IP Address Subnet Mask Default Gateway Address DNS (Required) usually two is given to you
The info above is provided to you by your DSL/Cable Internet provider
Step 3
Click on DHCP tab
Check Enable DHCP (this is useful if you do not want to set up static IP info on every computer that shares the internet connection) Starting IP Address: 100 (this means you can assign IP address to individual computers from 2-99, from 100 to 250 will be used in the DHCP IP address pool) Number of DHCP Users: 150 (this means up to 150 computers may share the DHCP IP address pool) Click Apply when done.
Note: You may chane the numbers to fit your need. Home users may only want 5 IP address in the DHCP pool.
Step 4
Click Advanced tab
Then Click DMZ Host (DeMilitarize Zone)
Enter the IP address of the DVR/Surveillance system This allows all internet traffic to go directly to your DVR/Surveillance system
In this case, the DVR/Surveillance system is on IP Address 192.168.1.10
Click Apply
TIPS
If you use Dynamic IP Address with Cable Modem
Make sure your Cable Modem is on battery back up and should not be shut down. Everytime it is turned off, you will get a new IP address. If this is the case, you will need to find the new IP address number and enter it into the Lycast Systems > Webcam Server > Server Setup > Assign Gateway IP Address
